‎Sensors | Page 6 | SimpliSafe Support Home
Skip to main content

Conversation List

Filter by

(53)
SA
Glassbreak Sensor Not Responding

The warning ‘Sensor Not Responding’ for a Glassbreak Sensor can be caused by a couple of things, including a low battery or a weak connection between the device and the Base Station.As a first step, we’d recommend ensuring that the battery is correctly installed. To do this:Slide the sensor off its’

Errors / Warnings

Help Center Article

 • 

Glassbreak Sensor

SA
How To Replace Glassbreak Sensor Battery

The Glassbreak Sensor takes a single CR-123A Lithium 3V battery and has a life expectancy of up to 3 years depending on placement and usage.To change your Glassbreak Sensor battery, slide the sensor up and off its bracket. Then, replace the lithium battery and put the device back in place.If your se

Battery / Power

Help Center Article

 • 

Glassbreak Sensor

How Does the Entry Sensor Respond During an Alarm

When the system is in an armed state (Home or Away Mode) and an Entry Sensor is triggered, the entry countdown will begin. The entry countdown by default is 30 seconds, however, this can be adjusted at any time within the SimpliSafe® App.If the system is disarmed within 30-60 seconds of the initial

Install / Set Up Help

Help Center Article

 • 

Entry Sensor

SA
How do I remove my Entry Sensor magnet (the smaller part of the sensor) from the wall?

The Entry Sensor magnet uses a slightly different adhesive than the other sensors. Remove the magnet by rotating the magnet slowly until the adhesive loosens and you can pull it off the wall.

Install / Set Up Help

Help Center Article

 • 

Entry Sensor

SA
Entry Sensor Offline

If your Entry Sensor is showing as offline on the SimpliSafe® Mobile App, this is an indicator that the battery within the device needs to be replaced. The Entry Sensor takes a single (1) CR-2032 Lithium 3V battery and has a life expectancy of up to 5 years depending on placement and usage.To replac

Errors / Warnings

Help Center Article

 • 

Entry Sensor

SA
How to Replace Entry Sensor Battery

The Entry Sensor takes a single CR-2032 Lithium 3V battery and has a life expectancy of up to 5 years depending on placement and usage.To change your Entry Sensor battery, slide the sensor up and off its' bracket. Then replace the lithium battery and slide the sensor back onto its bracket.If your se

Battery / Power

Help Center Article

 • 

Entry Sensor

SA
Adhering Sensors to Surfaces

Installing SimpliSafe® sensors takes less than a minute! In most cases, sensors can be mounted on walls by using the adhesive strips on the back of each device. However, there are some situations where the sensor may not adhere to the wall effectively, like:Brick surfaces: the surface can be rough i

Install / Set Up Help

Help Center Article

 • 

Sensors