‎Motion Sensors | SimpliSafe Support Home
Skip to main content

Conversation List

Filter by

(22)
How do Motion Sensors Respond During an Alarm

You can configure your Motion Sensor to detect motion in any system arming state (Off, Home, Away). Depending on how your Motion Sensor is set up, either the entry countdown will begin or the alarm will immediately sound should Instant Trigger be enabled. How the Motion Sensors Respond When Using En

Install / Set Up Help

Help Center Article

 • 

Motion Sensors

SA
Motion Sensor Gen 2 False Alarms

False Alarm CausesOur Motion Sensors have been designed to avoid false alarms. However, if you’ve experienced one, there are a few potential issues that may cause them:Direct sunlight hitting the sensor can trigger a false alarm. Heating vents located in the room. If they are located within the sens

Troubleshoot an Issue

Help Center Article

 • 

Motion Sensor Gen 2

SA
Motion Sensor Gen 1 False Alarms

SimpliSafe’s Motion Sensors have been designed to avoid false alarms. However, if you’ve experienced one, there are a few potential issues that may cause them.

Troubleshoot an Issue

Help Center Article

 • 

Motion Sensor Gen 1

Low Battery Warning for Motion Sensor Gen 2

The Motion Sensor Gen 2 takes a single CR-123A Lithium 3V battery and has a life expectancy of up to 4 years depending on placement and usage.If you are receiving this error shortly after installing your Motion Sensor Gen 2, this may be related to a firmware issue rather than a low battery within th

Errors / Warnings

Help Center Article

 • 

Motion Sensor Gen 2

SA
How To Replace Motion Sensor Gen 1 Battery

The Motion Sensor takes one (1) CR-123A Lithium 3V battery and has a life expectancy of up to 5 years depending on placement and usage.To change your Motion Sensor battery, slide the sensor up and off its bracket. Then replace the battery and slide it back onto its bracket.If your sensor is still of

Battery / Power

Help Center Article

 • 

Motion Sensor Gen 1

SA
How to Replace Motion Sensor Gen 2 Battery

Are you receiving a low battery warning on your Motion Sensor Gen 2 shortly after installing the sensor? If so, this may be related to a firmware issue rather than a low battery within the device. The Motion Sensor Gen 2 takes one (1) CR-123A Lithium 3V battery and has a life expectancy of up to 4 y

Battery / Power

Help Center Article

 • 

Motion Sensor Gen 2

SA
Motion Sensor Gen 2 Installation Guide

OverviewMotion Sensors are always on the lookout for uninvited guests. They can detect motion within 35 feet, with a 90-degree field of view. The Motion Sensor Gen 2 also has Pet Mode to distinguish between people and pets. Before Getting StartedYou’ll need to have a Gen 3 SimpliSafe® System install

Install / Set Up Help

Help Center Article

 • 

Motion Sensor Gen 2