1 Message
SmartLock not aligning to cylinder
I am using the red plastic piece.
It does not align with the smartlock unless I turn it almost 45-degrees.
I've tried to flip the plastic piece, I've looked to see if I could adjust the cylinder, but no luck.
Any ideas?
Official Solution
davey_d
Community Admin
•
5.7K Messages
2 years ago
Hi @cdburns123 yes, I would recommend that you start at that angle when you install. During the calibration step, the lock will determine the true positions of "open" and "closed".
1
0
cpcmm007
2 Messages
2 years ago
My kwikset standard type deadbolt has the pin position at the 3 o’clock position when deadbolt is at open position. The simplisafe lock wants the pin to be positioned at about the 2 o’clock position at the open position. Consequently the kwikset deadbolt is partially extended when the simplisafe lock is installed. I set it up and the lock tried to calibrate but went into error. Need some help.
0
0
cjthom
1 Message
2 years ago
I'm having the same issue. Has there been any resolution to this?
3
0
chriskh
2 Messages
1 year ago
So I had this exact same problem on my kwikset. The solution after hours of trying things is hard. Simply flip the red piece over on the male lock section. Lol. There is a front and back side of the price.
1