‎snooze for camera | SimpliSafe Support Home
 
gary220808's profile

Sunday, July 7th, 2024 3:07 PM

snooze for camera

Is there a way to turn off outdoor camera for more than an hour at a time ?  When there is a lot of activity it really runs down the battery.  It looks like the maximum time to "sleep" is one hour. 

Community Admin

 • 

3.4K Messages

5 months ago

Hi @gary220808, 

Unfortunately the Snooze Notifications setting cannot be extended longer than an hour in one go. After the initial hour is up, you will need to pause notifications again until you're ready to receive them.

You can turn off the camera's motion detection in the SimpliSafe mobile app by going to My System > Camera Settings > select [your Outdoor Camera] > toggle Motion Detection off. But if you do that you will need to turn Motion Detection back on once you're ready for the camera to record again.

2 Messages

@emily_s​ 

Therein is the problem. It would appear from prior posts that many users are frustrated with the inability to have motion notifications of the outdoor camera linked to the status of the system.  That is, when the system is off, the motion notification is off.  I am led to believe that the company is working on an update to do just that.  

Is that not true ? 

Battery drain because of the constant notifications  when the system is off requires constant changes of batteries.  So BUY, and keep extra battereris CHARGED, or go without outdoor protection when it IS needed and the system is in a HOME or AWAY condition. 

Please - SIMPLISAFE, respond to this defect in your system. 

 

Community Admin

 • 

3.4K Messages

@gary220808​ Yes, our devs are working on a feature that allows you to tie the Outdoor Camera's motion detection to the system's armed state so it does not record in Off Mode. This feature is in active development, and once it's ready to roll out we will provide an update over in this thread in the Community.

2 Messages

4 months ago

I have set up my system and been learning it for a week or so.   I can successfully create a setup where a door sensor triggers four cameras to record activity in their zone but how do setup so a camera sensor triggers also triggers an event that does the same.  I have a camera looking out the front window to the porch, and it did not notice my friendly neighborhood Jehovah witness today, I know because the flyer was stuffed in the crack of the door.   And I want the outside camera that watches the driveway to trigger an event that causes all cameras to check in just like the door entry device cause to occur.  What am I missing here… I got over $800 here and still missing the primary mark a vehicle entering the property and a person walking up to the front door.  The house predates electric door bells.

This comment has been converted into a post
New to the Community? Get started by reading our Welcome Article and please be sure to review our Community Guidelines before posting.