‎Installing new windows | SimpliSafe Support Home
Skip to main content
 
jajohn1469's profile
jajohn1469

1 Message

Wednesday, October 26th, 2022 2:46 PM

Installing new windows

We are having new windows installed. How do we remove the sensors from the old windows and reinstall in the new windows?

Post

 • 

Updated 

1 year ago

356

2

0

Official Solution

davey_d

Community Admin

 • 

5.7K Messages

2 years ago

Hi @jajohn1469 ,

For the main Entry Sensor piece, you just want to slide the sensor itself off the mounting bracket. Here's a guide to show you which direction, depending on orientation:

Once done, you'll see the mounting bracket, which is likely held in place by the adhesive strip. You just want to pull gently but firmly on the adhesive tab until it stretches and loses grip. Like so:
And finally, for the magnet, you can wiggle it from side to side, and eventually the adhesive will give way: 

0

0

general_kaos

764 Messages

2 years ago

Assuming you are talking about SS sensors, unscrew (for screws) or pull off (for tape).  Once off, then reattach them.

2

0

zebraboys

1 Message

Is replacement tape needed? And if so, can I acquire this from SS?

(edited)

Like

Reply

1 year ago

0

captain11

Captain

 • 

6.2K Messages

@zebraboys​ You can get the tape a lot quicker at Ace Hardware, Home Depot, Lowes etc. They are just 3M command strips.  BTW, for motion or glass break sensors in corners, highly recommend spending a bit more and get the velcro strips. Addresses uneven walls nicely. And yes, you can call SS support and they will send them to you too, usually at no charge.

Like

Reply

1 year ago

0

New to the Community? Get started by reading our Welcome Article and please be sure to review our Community Guidelines before posting.

Related Conversations

Loading...

Was this post helpful?